Construction Tutorial for Structural Insulated Panels (SIPs)

February 06th 2012

Testimonials

Thanks for doing an excellent job on my house panels.They fit really nice and tight.
-Stephen Schmidt-

Do you have a testimonial you would like to add to our list?

Panels HOWTO - Quick Menu
General Information	Floor Panels	Wall Panels	Roof Panels
Tools Required	Materials List	Fasteners	Sealant/Caulk
Electrical Wiring	Plumbing & Vents	Panel Identification	Panel Connection

-Back to Previous Page-
metal header - 20 gauge metal laminated on EPS foam for header

IB Panels ® header system is built to be structurally sound as well as keeping our extreme R-factor. This type of header is our most common header system. We laminate 20 gauge metal onto EPS and then fasten it to OSB and 2x material. The OSB on the headers will be the same width as the R.O. (rough openings) of the window or door. The metal/foam case and 2x are 3" longer than the OSB to allow it to slide into the outside panels.

Contact Us at:
IB Panels ®
PO Box 723
50 West 100 South
Jerome, ID 83338
PH: 208-324-7184
FAX: 208-324-6740
Toll Free: 888-799-1398

NTA Listing Report # IBP031109-7

NTA Formaledhyde Report # IBP042210-17

IM 14 TIP 01 Design Guide

News from IB Panels ®
Habitat for Humanity - "Blitz Build" was completed in 108 hours. IB Panels ® were used for the floors and walls. The walls were stood up within 45 minutes. Article 1 - Article 2 - Article 3.

View This Home

Up to 50% more energy efficient.

Approximately 40% less on-site labor.

Highly efficient, insulated corners, patented design.

Oregon Registration # M397