Construction Tutorial for Structural Insulated Panels (SIPs)

March 20th 2010

Testimonials

It went together perfectly.
-Jack Brossman-

Do you have a testimonial you would like to add to our list?

Panels HOWTO - Quick Menu
General Information	Floor Panels	Wall Panels	Roof Panels
Tools Required	Materials List	Fasteners	Sealant/Caulk
Electrical Wiring	Plumbing & Vents	Panel Identification	Panel Connection

-Back to Previous Page-
Panel Identification:

Enlarge Photo		Continuous metal 2 x 10 stud for extra support in header.

Enlarge Photo		2x stud continuous along bottom of header and top of sill.

Enlarge Photo		1-1/2" horizontal wire chases run at 16" and 46" up from floor.

Enlarge Photo		Metal 2x4 stud on each side of panel allows for tongue and groove connection.

Enlarge Photo		1-1/2" vertical wire chase in every open or standard panel.

		Each of our panels are either open, standard, sill or header panels.

		Open panels have no metal in the panels and usually will have a recess of 1-1/2" on both sides.

Enlarge Photo		Standard panels will have one side with a typical 1-1/2" recess and the other will have a 3-1/2" metal stud on each side of the panel for the connection of the panels.

Enlarge Photo

Enlarge Photo		Header panels have a continuous 2x10 metal stud that runs 1-1/2" past the OSB. This stud will slide into recessed panels to give greater support to the header.

Contact Us at:
IB Panels ®
PO Box 723
50 West 100 South
Jerome, ID 83338
PH: 208-324-7184
FAX: 208-324-6740
Toll Free: 888-799-1398

News from IB Panels ®
Habitat for Humanity - "Blitz Build" was completed in 108 hours. IB Panels ® were used for the floors and walls. The walls were stood up within 45 minutes. Article 1 - Article 2 - Article 3.

View This Home

Up to 50% more energy efficient.

Approximately 40% less on-site labor.

Highly efficient, insulated corners, patented design.

ICC # PFC 5361

Oregon Registration # M397

Quality Control Agency - PFS Corporation
Madison, Wisconsin #98-33