Construction Tutorial for Structural Insulated Panels (SIPs)

July 29th 2010

Testimonials

The panels were unloaded by 11am and had them all standing by 7pm. Don't know why anybody would want to do traditional framing.
-Aronn Crozier-

Do you have a testimonial you would like to add to our list?

Panels HOWTO - Quick Menu
General Information	Floor Panels	Wall Panels	Roof Panels
Tools Required	Materials List	Fasteners	Sealant/Caulk
Electrical Wiring	Plumbing & Vents	Panel Identification	Panel Connection

-Back to Previous Page-
pull groove jet slowly, allowing depth adjustment bar to ride on rails of OSB

Cutting Panels: Take the groove jet and make sure that wire is set to appropriate depth. After the wire has heated up, pull the groove jet through the foam. Make sure and go slow enough that the groove jet is riding on the two sheets of OSB. Also, if the groove jet is pulled too quickly through the panel, the wire will bend and the foam will not have a true flat cut.

Contact Us at:
IB Panels ®
PO Box 723
50 West 100 South
Jerome, ID 83338
PH: 208-324-7184
FAX: 208-324-6740
Toll Free: 888-799-1398

News from IB Panels ®
Habitat for Humanity - "Blitz Build" was completed in 108 hours. IB Panels ® were used for the floors and walls. The walls were stood up within 45 minutes. Article 1 - Article 2 - Article 3.

View This Home

Up to 50% more energy efficient.

Approximately 40% less on-site labor.

Highly efficient, insulated corners, patented design.

ICC # PFC 5361

Oregon Registration # M397

Quality Control Agency - PFS Corporation
Madison, Wisconsin #98-33